• Ahmedabad, Gujarat, India
  • +91 853 029 0095

Sample Size Of Material Testing

Home Sample Size Of Material Testing

Brochure

Download Brochure

TYPE OF TESTING SHEET PLATE ANGLE BAR PIPE / TUBING
Chemical 50×25 50 x 50 50 Long 50 Long 50 Long
Tensile 50 W x 300 L 50 W x 300 L 300 long 350 Long 350 Long
Bend 50 W x 300 L 50 W x 300 L – 350 Long 400 Long
Hardness 50 x 50 50 x 50 50 x 50 50 Long 50 Long
Flattening – – – – 100 Full Ring
Flaring – – – – 150 Full Ring

AL undertakes Chemical Testing, Mechanical Testing. The following sample requirements will provide optimal sample size for our engineers to conduct the required tests. Your sample size meet the requirements listed below, Sample sizes larger than those listed will not present a problem, the table below is considered as a good reference point for most samples.

 

Wet Chemical Analysis

  • Metals Chips – 5 grams minimum, 10 grams preferred.
  • Time for Completion: 2 Days.

 

TMT Bar

  • 1 .2 Meter Long, Each Diameter having 3 Samples.
  • Test Conduct: Chemical Analysis, Tensile (Yield Stress, UTS, Elongation, Bend, & Rebend Test).
  • Time for Completion: 1 Day.

 

Weld Procedure Qualification:

  • The welded test plate should be a minimum of 300 mm Wide by 500 mm along the weld.
  • Test Conduct:
  • Time for completion – Min. 5 Days.

 

Note:

  1. All Dimensions are in mm.
  2. Grain direction is very important when submitting Plate or sheet for testing. Always mark direction with an arrow on the Sample/s.

Search